Draper BDS368 Bedienungshandbuch PDF herunterladen (Seite 12)

Fig.13

Fig.14

- 11 -

STRAIGHT SANDING (Fig.13):

Hold the work firmly with both hands,

keeping fingers away from the belt.

Straight pieces shorter than the belt table are

sanded by holding the workpiece lightly

against the belt. Move it back and forth

across the belt, keeping the end butted

against the stop fence. This fence prevents

the workpieces from slipping off the table.

USE EXTRA CAUTION WHEN SANDING THIN

PIECES.When finishing long pieces, remove

the stop fence

. Start the work at one end and

gradually push it to the other end. Feed it

slowly across the width, at the same time,

apply only enough pressure to allow the belt

to remove material. If the belt stalls and belt

pulleys slip while applying moderate

pressure, the belt requires more tension.

END SANDING ON THE SANDING BELT

(Fig.14):

It is more convenient to sand the ends of long

workpieces with the sanding belt in a vertical

position. Move the work evenly across the

sanding belt

.

OPERATION AND USE

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare