Draper SC1 Bedienerhandbuch PDF herunterladen (Seite 30)

Centralis Receiver

Inteo Remote Control

The Centralis Receiver is a single motor control designed for

residential use. It includes an integrated radio receiver, plus input

terminals for an optional low voltage switch. Using the Telis Transmit-

ters, it is possible to operate the controls individually or in groups. Two

user-deﬁ ned intermediate positions can be programmed. This control

is packaged in a weatherproof enclosure and includes watertight

strain-relief ﬁ ttings for wires entering the box.

MECHANICAL SPECIFICATIONS

Overall Dimensions:

L: 6 in. W: 4¼ in. D: 2¼ in.

Typical Range (Optimal Conditions): 65 ft.

ELECTRICAL SPECIFICATIONS

Voltage Ratings:

INPUT: 120 VAC +/- 10% 50/60 Hz.

OUTPUT: 120 VAC 5A 1/4 HP

Approvals: The Centralis Receiver is UL508 for industrial controls

(UL, cUL). Complies with the National Electrical Code (NEC) and FCC

Standards.

OPERATING INSTRUCTIONS

System Set Up

➀ With power off, wire Centralis as indicated above. Turn all circuit

breakers on (motors should not move).

➁ Set the Centralis Receiver into programming mode by pressing the

programming button on the receiver until the LED lights solid

(about 5 seconds).

➂ Press the programming button on the Telis1 or Telis4 transmitter.

Make sure the desired channel is selected on the Telis4 before

programming. The programming LED on the Centralis will blink

indicating the transmitter has been memorized.

➃ Operate each motor in the DOWN direction using the radio

transmitter.

➄ The motorized window covering should move down or out. If this is

incorrect, turn off the circuit breakers and reverse the red and black

wires of the motor.

Operating Procedures

TRANSMITTER

➀ Pressing the UP button on the Telis transmitter will move the window

covering up or in. The DOWN button will move the treatment down

or out.

➁ To stop the motorized product at any time, press the CENTER but-

ton on the transmitter.

➂ To reach one of the intermediate positions, the awning or rolling

shutter must ﬁ rst be at the upper or lower limit, and stopped. Press-

ing the center button on the transmitter will move the window cover-

ing to the desired position.

LOW VOLTAGE SWITCH

➃ If desired, a single pole, single throw switch can be connected to

the low voltage terminals as indicated above. Each press of the

switch will sequence through the directions as follows;

DEPRESS 1 UP DIRECTION

DEPRESS 2 STOP

DEPRESS 3 DOWN DIRECTION

DEPRESS 4 STOP

Page 30 of 120

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare

Draper SC1 Bedienerhandbuch Seite 30

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Draper SC1