Draper SC1 Bedienerhandbuch PDF herunterladen (Seite 52)

Page 2 of 2

IntelliFlex Wall Switch by Draper

www.draperinc.com(765) 987-7999

Hardwired “Bus” Command Switch

RF “Bus” Command Switch

Dry Contact Switch (not programmable)

Programming IntelliFlex Switch

Dry Contact: Does not have a Bus connection, and is not programmable. It is

somewhat conﬁ gurable, based on how it is connected—it must be connected

directly to each device it is controlling.

Bus: Programming requires physical contact with the back of the switch. This

allows programming of which button sends which command, and other options.

The switch must be powered by installing it on the SC1 Bus. Plug it into any

available “Eye” jack.

RF: Battery operated. Programming the RF switch requires physical contact with

the back of the switch, and allows programming of which button sends which

command, along with other options. When replacing batteries, test switch to make

sure it works. If not, remove batteries, wait a few seconds, then re-insert them. The

switch may operate with low batteries, but programming may not work.

Programming Switch “Locally” Using IR Transmitter

Press programming button on back of switch. Red LED on back of switch will

come on, indicating it is in program mode. This method uses the eye on the back of

the switch, so you must use an IR transmitter for programming, and you must have

access to the back of the switch. Bus commands are ignored during this process.

To set button “#” on the switch to send a new “command”:

➀

Press programming mode button on back of switch (red LED appears).

➁

Press and release the switch button you want to program. The LED will change

from red to green.

➂

Press the command on the IR transmitter you want to be assigned at the

button you just selected (pressing “Stop” at this point will assign the stop

command to the selected button).

➃

The LED will go back to red and you are back in program mode; e.g. to

program the top left button to send Close 7: press the top left button, then

press Close 7 on the IR transmitter.

Clear button “#”:

Press programming mode button on back of switch (red LED will appear). Press

OPEN “#” on the IR transmitter, where “#” is the switch button number to clear. The

red LED will blink off then back on, and you are back in program mode.

Reset to factory default:

Press programming mode button on back of switch(red LED will appear). Press

CLOSE ALL on IR transmitter. The red LED will blink off then back on, and you are

back in program mode. If this is an RF switch, the radio address will not change.

Exit programming mode:

Press STOP on the IR transmitter, and LED will turn off; or, LED will turn off

automatically after 10 seconds of no IR commands or buttons pushed.

Please Note

The eye on the back of the switch is only for programming and will not act as a

receiving eye.

Program

Button

"Eye"

Jack

Program

Button

"Eye"

Jack

(Switch

Front/

Button

Map)

COM

(Switch Back/

Board Map)

Please Note: This draw-

ing indicates all possible

connection and button

locations. Your switch

may not have the same

number of buttons or

connections, but their lo-

cations will be consistent

with these "maps."

Dry Contact switch is

not programmable.

Page 52 of 120

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare

Draper SC1 Bedienerhandbuch Seite 52

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Draper SC1