Draper SC1 Bedienerhandbuch PDF herunterladen (Seite 62)

SUN AND WIND SENSOR V1.l and SUN SENSOR SWITCH V4 by Draper Page 7 of 9

Press an open or close command on the IR transmitter and make sure the appropriate action happens on the SC1

system.

Draper Sun Switch (DSK) (optional):

This Sheet uses $ for this Sun Sensor Switch's accessory number - new units will use a 6 where the # is (ALL also

works).

14 This means open + close, all others are turned off

15 This means whatever “button" you want to "send" when the button is pushed.

Sun Sensor Switch MUST be plugged into the Sun Sensor Switch (DSK) jack for it to work correctly.

Defaults:

Accessory number = 6.

Open button sends OPEN 1.

Stop button sends STOP (this is All Stop).

Close button sends CLOSE 1.

Sun & Wind Mode (both GREEN and RED LEDs will display on the Programming Switch).

It is possible to make the open & close buttons send commands that do not control this motor simulator, but this

would probably be confusing. The open/stop/close LEDs are updated according to the status of the SUN AND WIND

SENSOR ''motor simulator" to which it is connected regardless of any channel number (s).

Note that the default channel for the Sun Sensor Switch is 1 and the default channel for the SUN AND WIND

SENSOR is 22, so the Sun Sensor Switch channels should be changed to 22 for use with SUN AND WIND

SENSOR.

Power-Up

The LEDs go through a sequence where all LEDs are turned on so you may easily determine if any are not working.

After this sequence is completed, the Decorator Switch may take a few seconds before the correct state is displayed.

The sequence begins: All 6 RED LEDs on the Programming unit, then All 6 GREEN LEDs on the Programming

unit, then ALL 4 LEDs on the Control unit. Then the bottom 4 LEDs will flash RED for ¼ of a second indicating

WALL SWITCH is version 4. The version of the SUN AND WIND SENSOR must be 1 and the Sun Sensor Switch

must be 4 for correct operation.

Configuring the WALL SWITCH & SUN AND WIND SENSOR using the WALL SWITCH:

Press and hold the 2 buttons indicated below for 5 seconds to perform the configuration shown. After completion, the

LEDs next to the buttons held will come on green for 1 second. If 5 RED LEDs come on, then that configuration is

not allowed.

Sun & Wind Display:

Medium-high (3d) and medium-low (5th) buttons. The Sun Sensor Switch will display and set both Sun and Wind.

The SUN AND WIND SENSOR does not change any settings.

Sun Only Display:

Medium-high (3d) and low (6

) buttons. The Sun Sensor Switch will display and set only Sun. Multi-positions on

sun are not affected. This does not stop wind detection; the Sun Sensor Switch will just never report wind levels and

the user cannot select a wind threshold.

The SUN AND WIND SENSOR does not change any settings.

Page 62 of 120

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 119 120

Keine Kommentare

Draper SC1 Bedienerhandbuch Seite 62