Draper SC1 Bedienerhandbuch PDF herunterladen (Seite 37)

IntelliFlex™ GC4

The GC4 (group control 4 motors) prevents feedback between motors and allows multiple motors to run off a 120V switch. The switches that

Draper supplies are 15A so twelve standard motors or three GC4' s are able to run off one switch with GC4' s. To further help you decide if a

GC4 is right for you, here are some conditions in which you would use them:

- You want to run multiple shades at one time, together off of 1 high voltage wall switch.

- You want controls in an electrical enclosure and a UL rating on the assembly.

- You want to "home run" wires to a control location.

- You want the cheapest, most effective way to control up to 12 motors from one high voltage switch.

GC4' s are not to be used if the following are your conditions.

- You are planning at any point and time to run the shades from a low voltage system such as AMX, Crestron, Vantage, etc.

. You want to operate a group of shades as two or more groups and together.

- You want to have preset intermediate stop action.

. You want to operate the shades from an IntelliFlex input device such as a sun sensor, IntelliFlex wall switch, IR remote, RF

remote, etc.

- You want the controls to be remotely located near the motors to reduce wiring.

- You want to upgrade the system at a later time to work from a computer or other low voltage switching device.

Page 37 of 120

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 119 120

Keine Kommentare

Draper SC1 Bedienerhandbuch Seite 37