Draper SC1 Bedienerhandbuch PDF herunterladen (Seite 57)

SUN AND WIND SENSOR V1.l and SUN SENSOR SWITCH V4 by Draper Page 2 of 9

The Program Mode LED must now be lit solid GREEN, if it is not, repeat the above steps.

The SUN AND WIND SENSOR will automatically exit program mode after 20 seconds if no commands are

received.

If programming commands started via an eye on the BUS, then BUS must be used to complete this programming.

The same goes for the Sun Sensor Switch jack. While in programming mode, commands seen on either jack are

repeated to the other.

While in programming mode, sun and wind sensors and all switches are ignored.

When program mode exits, the sun sensor is reset to where the level is now, there are no pending events.

SUN AND WIND SENSOR Configuration

This Sheet uses "#" for this unit's accessory number - new units will use a 1 where the # is (ALL also works).

The accessory number is reset to 1. Radio address is not changed

Defaults:

Accessory number = 1, Plugged into SC1 (RP) Bus, Standard Wind Timing.

For the most reliable operation, this unit should be hardwired to the SC1 system. If that is not practical, the SUN

AND WIND SENSOR may be connected to an RFTM for wireless operation. Please see "Installing SUN AND

WIND SENSOR using radio (RFTM): Step by Step" for more info.

Putting the SUN AND WIND SENSOR in Demo Wind Timing mode is useful for demonstrating the unit to a

potential client without having to wait several minutes to see actions. Demonstrating the Sun Sensor is achieved by

setting a fast Sun Delay Time as described under the Sun Sensor section of this document.

Command send time is not selectable. It is 1/4 second for all commands. This means the controlled SC1 action must

not be momentary, or they must be sticky, which is what is recommended in the notes.

Page 57 of 120

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 119 120

Keine Kommentare

Draper SC1 Bedienerhandbuch Seite 57