Draper SC1 Bedienerhandbuch PDF herunterladen (Seite 48)

IntelliFlex™ IR Remote Control by Draper Page 2 of 2

www.draperinc.com

(765) 987-7999

The complete table of codes (in hex) is:

Installing IR Eye Only into J-Box

Infrared Cover fits in Decora Plate

1" flat head screws in J-box

IR Codes

IR wavelength is 950 nm. Light is modulated at 38 KHz with 1/3 duty

cycle.

An on pulse must be at least 158 µseconds (µs) long (6 cycles) and

should not be longer than 448 µs (17 cycles).

From the start of a pulse till the start of the next pulse is 1050 µs for a “0

bit”, and 2000 µs for a “1 bit”.

A Flash is 11 pulses (10 bits), minimum time between ﬂ ashes (interﬂ ash

time) is 11 mseconds (ms). When using the small eye the minimum interﬂ ash

time is 25 ms, 30 ms is recommended. There is NO preamble.

Channel 1 OPEN sequence is 0101000010. The sequence always starts

with 01, so for simplicity strip that off, and we get 0100 0010 = hex 42 (see

ﬁ gure below).

Please Note: low = off, high =38 KHz signal on.

Flash Interflash Time (30 ms)

1050 µs

2000

2000 µs

time

00 0

OPEN1 42 OPEN13 40

CLOSE1 22 CLOSE13 20

OPEN2 62 OPEN14 60

CLOSE2 12 CLOSE14 10

OPEN3 32 OPEN15 30

CLOSE3 0a CLOSE15 08

OPEN4 4a OPEN16 48

CLOSE4 2a CLOSE16 28

OPEN5 1a OPEN17 18

CLOSE5 06 CLOSE17 04

OPEN6 46 OPEN18 44

CLOSE6 26 CLOSE18 24

OPEN7 16 OPEN19 14

CLOSE7 0e CLOSE19 0c

OPEN8 56 OPEN20 54

CLOSE8 36 CLOSE20 34

OPEN9 4e OPEN21 4c

CLOSE9 2e CLOSE21 2c

OPEN10 5a OPEN22 58

CLOSE10 3a CLOSE22 38

OPEN11 02 OPEN23 1c

CLOSE11 72 CLOSE23 70

OPEN12 6a OPEN24 68

CLOSE12 66 CLOSE24 64

OPEN ALL (1-12) 76 OPEN ALL (13-24) 74

CLOSE ALL (1-12) 6e CLOSE ALL (13-24) 6c

STOP 52

IR Eye Only

Splitter

Modular Jack Adapter

Modular Cable Coupler

Optional Cable Accessories

A Note on Wiring

The IR Receiver Eye must be plugged in to an open "Eye" jack (see diagram

on page 1). All input devices connect using electrically straight 4-conductor

modular cable.

Please note: If you use standard telephone cable, you must ﬁ rst remove one

connector, turn it over and re-attach, to ensure that the cable is electrically

straight (see diagram below).

Please Note:

Draper recommends using a PDA or PC to program your IntelliFlex

controls. Software is available at www.draperinc.com.

For button press sequences to manually program, see “SC1 Quick Refer-

ence Guide” at www.draperinc.com

Page 48 of 120

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare

Draper SC1 Bedienerhandbuch Seite 48

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Draper SC1