Draper SC1 Bedienerhandbuch PDF herunterladen (Seite 56)

Installation and Programming Guide

Sun and Wind Sensor V1.l and Sun Sensor Switch V4 by Draper, Inc.

Connect to the Sun and Wind Sensor as shown:

All wires labeled “Common” are connected together and are electrically the same as the Black wire on the Bus; any

common wire can be used in place of any other common wire in the drawing.

The Light Sensor may be connected to the spring-loaded connector or to the sensor jack. For best results, use only

one of the Light Sensors shown. More than one light sensor can be installed on either or both connections; however,

if this is done the sensors' scale is disturbed. Sharing a Light Sensor between two Sun and Wind Sensors is not

supported. The actual light sensor is the small round device in the box. This part does not have to be in direct

sunlight, but it may be if desired. (If the indoor white box is in direct sunlight it may discolor over time.) The small

white box must NOT be mounted outdoors—it is NOT weatherproof. A weatherproof sensor may easily be

connected to the spring-loaded connector. If the sensor becomes disconnected, then the control unit will not be able

to detect sunlight and will report total darkness all the time. The wire to the light sensor may be up to 500 feet long

and wire type and gauge does not matter, but exterior rated wire should be used if the wire is exposed to the

elements. When connected to a modular jack, this sensor uses the black and green wires as shown.

The two BUS jacks are electrically connected together in parallel.

5VDC Power (the red wire) is shared between BUS and Sun Sensor Switch (DSK) jacks.

Commands on the Sun Sensor Switch jack are repeated to the BUS jacks, and vice versa.

This unit works well with other accessories on the same SC1 Bus.

SUN AND WIND SENSOR LED:

The LED is bi-colored.

-On power-up, the LED will blink red, green if unit is Bus, green, red if unit is RF (lowercase indicates short LED

blink, while UPPERCASE indicates LONG LED blink).

-The GREEN LED will flash briefly whenever the unit is transmitting to the SC1 Bus or via RF.

-The GREEN LED on solid indicates program mode. Note this is opposite the Sun and Wind Sensor.

-The RED LED will flash briefly whenever the unit is unable to transmit to the SC1 Bus due to traffic, indicating that

the command is being discarded.

SUN AND WIND SENSOR Accessory Enter Program Mode:

To Enter Program Mode:

-Using a programmable remote: press & hold STOP; while still holding STOP press both OPEN7 and CLOSE7.

-Release all three buttons; within 6 seconds press CLOSE 'N', where “N” represents the accessory number of this

device (factory default for N is 1), or CLOSE ALL will put all accessories in program mode. Note that Stop+7+7

Close 1 is supported by the R2D7 command: *1a01.

Page 56 of 120

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 119 120

Keine Kommentare

Draper SC1 Bedienerhandbuch Seite 56